Service manual

Chapter 2
2-20
When removing the harness [1] through the opening in the card reader mount, take care not to cut or damage it.
F-2-55
MEMO:
The removed card reader mount is no longer necessary.
5) Insert the card reader [2] harness and ground cable into the hole in the supplied card reader mount [1]. Using the screw [3] removed in step 1, secure the card
reader to the card reader mount.
When inserting the card reader [2] harness and ground cable, take care not to cut or damage them.
F-2-56
6) Using the supplied binding screw (M4x6) [1], connect the ground cable to the reader mount. Attach the supplied edge saddle [3] to the card reader mount.
F-2-57
7) Connect the connector [1] of the supplied repeating harness B to the connector [2] on the card reader. Using the supplied binding screw (M4x6), secure the
repeating harness B clamp [4]. Disconnect the shorting connector [5].
If the shorting connector [5] is not disconnected, a malfunction or error can result. Therefore, the shorting connector must be disconnected.
MEMO:
The removed shorting connector is no longer necessary.
[1]
[1]
[3]
[2]
[1]
[3]
[2]