Service manual

Chapter 15
15-2
F-15-2
When using the SST, select "#DOWNLOAD" in the service mode to place the main unit in the download mode. (The finisher need not enter the download mode.)
15.2 Making Preparations
15.2.1 Registering the System Software
0011-1866
iR2016J / iR2016 / iR2020 /
System software programs to be downloaded need to be registered in the SST.
The system software programs are registered with the names listed below.
<Software Programs Preinstalled in Main Unit>
Machine name:iR2020
Unit name:
- Main controller: System
- Boot program: Boot
- PCL board: PCL
The system software registration program is explained below taking System as an example.
[Preparation]
Have the following ready:
- PC in which SSTv3.21 or later is installed
- System CD supplied with iR2020
[System Software Registration Procedure]
1) Start the PC.
2) Insert the system CD in the PC.
3) Start SST.
4) Click the "Register Firmware" button.
CPU
USB cable
RS232C
straight cable
Image processor PCB
16MB ROM
Finisher-U1
Finisher controller PCB
Main unit
Downloader
PCB
FY9-2034
PC
J303
Flash ROM
Flash ROM
CPU
Flash ROM
J918
System
software
SST
16MB ROM PCB
USB Memory
Flash Memory