Service manual

Chapter 9
9-6
F-9-14
3) Pull out the handle [1] at the back of the machine, remove the screw [2],
and then remove the stopper [3].
F-9-15
4) Disconnect the two connectors [1], and then remove the harness [2] from
the wire saddle [3].
F-9-16
5) Remove the three screws [1], and then remove the handle unit [2].
F-9-17
6) Release the gear stopper [1] from the shaft, and then remove the gear [2].
F-9-18
7) Remove the six screws [1], and then remove the main drive unit [2].
F-9-19
Since the gears in the main drive unit are not secured, gears will fall if the
main drive unit is inclined. If gears should fall, install them at the positions
shown below.
F-9-20
9.4.2 Fixing Drive Assembly
9.4.2.1 Removing the Drum Unit
0011-0607
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
[1][3][2]
[2]
[1] [3]
[1][1][3]
[2]
[1] [1]
[2]
[2]
[1]
[1][1] [2]
[1]