Service manual

Chapter 7
7-13
F-7-34
To prevent exposure to light, cover the drum with several sheets of copy
paper and place it in a safe place.
Open the left door fully to prevent the damage to the drum unit
7.5.7.2 Removing the Transfer Registration Unit
0012-6072
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Remove the four screws [1], and then remove the transfer registration unit
[2].
F-7-35
7.5.7.3 Removing the Feed Guide
0012-6073
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Remove the two screws [1], and then remove the feed guide [2].
F-7-36
7.5.7.4 Removing the Multifeeder Pickup Roller
0012-6074
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Remove the bearing [1], and then remove the multi-paper roller [2].
F-7-37
When installing the multifeeder pickup roller, pay attention to the orien-
tation.
Left-side axis: [1] Long Right-side axis: Short [2]
F-7-38
7.5.8 Manual Feed Tray paper sensor
7.5.8.1 Removing the Drum Unit
0011-0672
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Open the front cover [1].
2) Turn the developer pressure release lever [2] clockwise, and then open the
left door [3].
3) Draw out the drum unit [4].
F-7-39
To prevent exposure to light, cover the drum with several sheets of copy
paper and place it in a safe place.
Open the left door fully to prevent the damage to the drum unit
7.5.8.2 Removing the Transfer Registration Unit
0011-0673
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Remove the four screws [1], and then remove the transfer registration unit
[2]
[1]
[3]
[4]
[1]
[1]
[2]
[1]
[2]
[1]
[2]
[1]
[2]
[2]
[1]
[3]
[4]