Service manual

Chapter 4
4-21
F-4-58
4.4.3.4 Removing the Left Cover (Rear)
0010-6098
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Remove the three screws [1], and then detach the left cover (rear).
F-4-59
4.4.3.5 Removing the Reader Rear Cover
0010-6099
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Open the copyboard cover (or ADF).
2) Remove the screw, and then detach the small cover [2].
F-4-60
3) Remove the screw [1], and then disconnect the ground cable [2] of the
ADF harness.
4) Disconnect the four connectors [3], and then remove the ADF harness [4].
F-4-61
When installing the ADF harness [4], fit the harness band [5] in the
groove in the reader rear cover.
5) Remove the four screws [1], and then detach the reader rear cover [2].
F-4-62
4.4.3.6 Removing the Scanner Motor
0010-4303
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Disconnect the connector [1], and then remove the two screws [2].
2) Remove the spring [3], and then remove the scanner motor [4].
F-4-63
4.4.4 Contact sensor
4.4.4.1 Removing the Rear Cover
0010-6100
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Remove the four screws [1], and then detach the rear cover [2].
[2]
[1]
[2]
[1]
[2]
[1]
[1]
[2]
[3]
[4]
[5]
[1]
[2]
[1]
[4]
[2] [3] [2]