Service manual
Chapter 4
4-20
F-4-52
6) Go to the back of the machine, and then disconnect the four connectors [1]
from the reader controller PCB.
7) Remove the harness from the edge saddle/clamp [2].
8) Remove the flexible cable holder [3], and then disconnect the two flexible
cables [4].
9) Remove the two screws [5].
F-4-53
10) Remove he two screws [1], and then remove the flexible cable guide [2].
11) Remove the reader controller PCB [3] together with the mount.
F-4-54
12) Remove the three screws [1], and remove the reader controller PCB [2]
from the mount.
F-4-55
4.4.3 Scanner Motor
4.4.3.1 Removing the Rear Cover
0010-6095
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Remove the four screws [1], and then detach the rear cover [2].
F-4-56
4.4.3.2 Removing the Right Cover (Lower)
0010-6096
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Open the front cover.
2) Remove the five screws [1]. Remove the two hooks [2], and then detach
the right cover (lower) [3].
F-4-57
4.4.3.3 Removing the Right Cover (Upper)
0010-6097
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
1) Remove the screw [1], and then detach the right cover (upper).
[2] [4][3]
[4]
[1] [4]
[5][2][1]
[1]
[2]
[4]
[3]
[2]
[5]
[2]
[1]
[3]
[2]
[1]
[1]
[2]
[1]
[2]
[3]
[1]