Service manual

Chapter 2
2-32
2.7 Installing the Reader Heater
2.7.1 Preparing the parts
0011-3368
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
Before installing, make sure the heater PCB has been installed.
1) Prepare the following parts.
F-2-86
2.7.2 Installing the Reader Heater Harness
0011-3371
iR2016J / iR2016 / iR2020 / / iR2016i / iR2020i
Before installing, make sure the host machine is turned off. If it is turned on, go through the following:
1. Turn off the main power switch.
2. Disconnect the power cable (from the power outlet).
3. Disconnect the power cable.
[1] Reader heater 2 pcs.
[2] Heater harness 1 pc.
[3] Harness guide 1 pc.
[4] Right heater base 1 pc.
[5] Heater cover 2 pcs.
[6] Clamp 6 pcs.
[7] TP screw (M3x6) 5 pcs.
[1]
[4]
[5] [6] [7]
[2]
[3]