Service manual

Chapter 2
2-29
F-2-80
3) Install the edge saddle (large) [1] and connect one heater switch harness [2] to the connector (J1901) on the heater PCB. Route the other harness [3] to the front
of the host machine through the saddle.
F-2-81
4) Install the edge saddle (small) [1] on the power supply unit at the front of the host machine, and then connect the header switch harness [2] (routed to the front
of the host machine) to the connector (J15) on the power supply PCB through the edge saddle.