User`s guide

Loading Paper
2-4
Routine Maintenance
2
4 Load the paper stack into the paper drawer.
Even out the edges of the paper stack. Load the paper
stack against the right wall of the paper drawer.
When loading paper into the paper drawer for the first time,
set the size plate and the paper-size detecting lever for the
paper being loaded. (See “Adjusting a Paper Drawer to
Hold a Different Paper Size,” in the Reference Guide.)
When loading paper into the paper drawer, make sure that
the paper size setting of the paper drawer matches the size
of paper. (See “Adjusting a Paper Drawer to Hold a
Different Paper Size,” in the Reference Guide.)
IMPORTANT
• Paper which has been rolled or curled must be straightened
out prior to use.
• Make sure that the height of the paper stack does not
exceed the loading limit mark ( ) at the back of the paper
drawer and the corners are below the paper size guide clips.
• Be sure to set the paper-size detecting lever correctly. If the
lever is set to the wrong position, paper jams or dirty prints
may occur, or the inside of the machine may get dirty.
NOTE
• Each paper drawer holds approximately 250 sheets of paper
(80 g/m
2
).
• If there are instructions on the package of paper about which side of the paper to load, follow those
instructions.
• When the paper is loaded into the paper drawer, the side facing up is the one printed on.
• If problems occur, such as poor print quality or paper jams, try turning the paper stack over, and reload
it.
• For more information on the print direction of preprinted paper (paper which has logos or patterns
already printed on it), see “Relationship between Original Orientation and Preprinted Paper Output
Chart,” in the Reference Guide.
Downloaded from ManualsPrinter.com Manuals