Service manual

8
(Operator Call Errors cont'd)
Alarm LED
blinking in
orange
Error [Error code] Solution Remarks
13 times The remaining ink amount
unknown. [1683]
Replace the applicable ink tank with a
new one, and close the top cover.
Printing with a once-empty ink tank can
damage the printer.
To continue printing without replacing the
ink tank(s), press the Resume/Cancel
button for 5 sec. or longer to disable the
function to detect the remaining ink
amount. After the operation, it is recorded
in the printer that the function to detect
the remaining ink amount was disabled.
The error is indicated when raw
ink is detected but the dot count
number exceeds the threshold of
complete exhaustion of ink.
14 times Ink tank not recognized.
[1684]
A non-supported ink tank is installed (the
ink tank LED is turned off). Install the
supported ink tanks.
15 times Ink tank not recognized.
[1410 to 1414]
An error occurred in an ink tank (the ink
tank LED is turned off). Replace the ink
tank(s).
Each error code corresponds to each ink
tank, from left (the opposite side of the
home position) to right, respectively.
Ink tank positioning (from left to
right):
BK, PigBK, Y, M, C
16 times No ink. [1688] Replace the empty ink tank(s), and close
the top cover.
Printing with an empty ink tank can
damage the printer.
To continue printing without replacing the
ink tank(s), press the Resume/Cancel
button for 5 sec. or longer to disable the
function to detect the remaining ink
amount. After the operation, it is recorded
in the printer that the function to detect
the remaining ink amount was disabled.
The error is indicated when "no
raw ink" is detected and when the
dot count number exceeds the
threshold of complete exhaustion
of ink.
*1: Only for models supporting CD / DVD printing
*2: Only for models not supporting CD / DVD printing