Service manual

24
*1: Refurbishment completion procedures:
At end of refurbishment of normal printers, set the printer to the default shipment conditions (with
the carriage locked in the home position, and the paper lifting plate in the raised position),
following the steps below.
(1) Install the print head, and while pressing and holding the Power button, connect the AC
plug.
(2) After the Power LED lights in green, with the Power button still pressed, press and release
the Resume/Cancel button 2 times, and release the Power button.
Resume/Cancel button pressing Alarm LED Power LED
First time Lights in orange. Turns off.
Second time Turns off. Lights in green.
(3) Open the front door and access cover.
The carriage moves to the print head
replacement position. (The Power LED blinks in green.)
(4) Remove the print head. (The Power LED blinks in green.)
(5) Press the Power button. (The Power LED lights in green.)
(6) Close the front door. (The Power LED blinks in green, then turns off.)
(7) Close the access cover.
(8) Remove the power cord.
(9) Pack the printer.