User manual

29
Step
3
18 Make sure that the levers near the drum cartridge guides on
the both sides are in the proper position as shown in the
figure.
19 Make sure that the labels on the projections of the drum
cartridge are visible.
If you cannot see any of the three colors on the label from the front, take out the
drum cartridge once, turn the projection (A) in the direction of the arrow until it
clicks and stops, and then reinstall the cartridge.
20 Slide the blue lock release lever (A) to the position of " "
to lock the drum cartridge.
Slide the lock release lever until the triangular mark on the lock release lever
aligns with the triangular mark on the label.
21 After installing all the drum cartridges, close the top cover.
Close the top cover of the printer while holding it by the lever (A) gently.
If you close the top cover forcefully, the ITB unit cover (B) may not move back to
the original position, and this may result in damage to the printer.
Make sure that all of the three colors
on the label are visible.
(A)
(A)
Align the triangular
marks.
(A)
(B)