User manual

26
Step
3
12 Hold the blue tabs (A) of the drum cartridge and shake it up
and down 10 to 12 times each as shown in the figure to
evenly distribute the developer inside the cartridge.
Hold the blue tabs of the drum cartridge.
Shake the drum cartridge up and down 10 to 12 times each as shown in the
figure.
IMPORTANT
If the developer is not distributed evenly, this may result in deterioration in
print quality. Be sure to carry out this procedure properly.
13 Place paper on a flat surface, place the drum cartridge on it,
and then fold back the tab (A) of the sealing tape as shown
in the figure.
IMPORTANT
• When placing the drum cartridge, be sure to place paper under the drum
cartridge to prevent a desk or others from being damaged by the bottom of
the drum cartridge.
• When pulling the sealing tape out, do not hold the area near the mouth of
the sealing tape with your hand. If the tape is severed, it may become
difficult to pull out completely.
• When pulling the sealing tape out, be careful not to hold the drum
protective shutter (A) with your hands.
(A)
(A)
(A)
Do not hold this part
with your hand.
(A)