User`s guide
Table Of Contents
- Manuals for the Machine
- How This Manual Is Organized
- Contents
- Preface
- How To Use This Manual
- Legal Notices
- All About Color
- Preserving Color Copies
- Introduction to Copying
- Basic Copying Features
- Special Copying Features - Document Layout
- Special Copying Features - Image Adjustment
- Special Copying Features - Scan Settings and Notifications
- Special Copying Features - Image Editing
- Special Copying Features - Color and Image Quality Adjustments
- Memory Functions
- Customizing Settings
- Appendix
Reserved Copying
1-37
1
Introduction to Copying
If you specify a reserved copy job while the machine is printing, copying of the
new job automatically begins when the current job is complete. If the following
screen is displayed, press [OK] ➞ try reserving the job again after the current job
is complete.
Scanning starts.
Using the Stack Bypass
You can perform reserved copying from the stack bypass by specifying in advance
the paper to be loaded for the next job. However, this is possible only if paper is
being fed from the stack bypass for the current job.
The following example assumes that 11" x 17" plain paper is being fed from the
stack bypass for the current job, and that you are selecting LTR plain paper to be
fed from the stack bypass for a reserved job.
NOTE
If Stack Bypass Standard Settings in Common Settings (from the Additional Functions
screen) is set to 'On', reserved copying can be performed only for the registered paper
size and type. (See Chapter 4, "Customizing Settings," in the Reference Guide.)
1
Place your originals ➞ set the desired copy modes.