User`s guide
Table Of Contents
- Manuals for the Machine
- How This Manual Is Organized
- Contents
- Preface
- How To Use This Manual
- Legal Notices
- All About Color
- Preserving Color Copies
- Introduction to Copying
- Basic Copying Features
- Special Copying Features - Document Layout
- Special Copying Features - Image Adjustment
- Special Copying Features - Scan Settings and Notifications
- Special Copying Features - Image Editing
- Special Copying Features - Color and Image Quality Adjustments
- Memory Functions
- Customizing Settings
- Appendix
Placing Originals
1-28
1
Introduction to Copying
2
Neatly place your originals with the side to be copied face up
in the original supply tray.
Place your originals as far into the feeder as they will go, until the Original Set
indicator is lit.
If any dirt on the original scanning area is detected when the originals are placed
in the feeder, the following screen appears. Even though streaks may appear on
the copies, you can proceed to scan your documents by pressing [Done]. It is
recommended, however, that you open the feeder, clean the scanning area, and
then close the feeder. The following screen will not appear once the scanning
area is clean. For instructions on cleaning the original scanning area, see
Chapter 7, "Routine Maintenance," in the Reference Guide.
If you still find streaks on the output after the original scanning area has been
cleaned, specify the Remove Background mode to erase the streaks. (See
"Remove Background," on p. 7-20.)
Original Set Indicator