User`s guide

Table Of Contents

Placing Originals

1-23

Introduction to Copying

NOTE

•

If the top edge of the original is not aligned with the back edge of the platen glass (by the

arrow in the top left corner), your original may not be scanned correctly, depending on the

copy mode that you have set.

•

Originals of the following sizes can be placed either vertically or horizontally. However,

the scanning speed for horizontally placed originals is somewhat slower than for

vertically placed originals. Place originals horizontally when scanning with a Preset

Zoom, such as when enlarging an LTR original onto 11" x 17" paper.

•

Horizontally placed LTR and STMT originals are referred to as LTRR and STMTR.

•

11" x 17" and LGL originals must be placed horizontally.

Platen Glass

You should use the platen glass when copying bound originals (such as books and

magazines), originals of heavy or lightweight paper, and transparencies. You should

also place originals onto the platen glass when you want to copy an

11" x 17" original with an image that extends all the way to the edges without the

periphery of the original being cut off. (See "Manual Paper Selection," on p. 2-9,

and "Entire Image," on p. 2-35.)

NOTE

The machine automatically detects the size of the following originals: 11" x 17", LGL,

LTR, and LTRR.

Lift the feeder/platen cover.

- Platen glass: LTR, STMT

- Feeder: LTR

Sensor