User`s guide
Table Of Contents
- Manuals for the Machine
- How This Manual Is Organized
- Contents
- Preface
- How To Use This Manual
- Legal Notices
- All About Color
- Preserving Color Copies
- Introduction to Copying
- Basic Copying Features
- Special Copying Features - Document Layout
- Special Copying Features - Image Adjustment
- Special Copying Features - Scan Settings and Notifications
- Special Copying Features - Image Editing
- Special Copying Features - Color and Image Quality Adjustments
- Memory Functions
- Customizing Settings
- Appendix
Area Designation
6-36
6
Special Copying Features - Image Editing
NOTE
•
If the designated area is rectangular, and you want to continue designating other
areas, repeat steps 5 to 7. Areas that have already been designated are displayed
with the new area.
•
To modify a designated area that was specified using the edit pen, press [Area Fine
Adj.] ➞ [Point select] until the screen displays the desired point that you want to
modify ➞ press [ ], [ ], [ ], or [ ] to move the point ➞ press [Done] ➞
[Preview] to check the modified area.
8
Press [OK] ➞ [Done].
The selected mode is set, and the display returns to the Copy Basic Features
screen.
NOTE
If there are multiple designated areas and [Framing] is specified for one or more of
the areas, press [Next] ➞ select [Shift center] or [Do not shift center] ➞ press [OK]
➞ [Done].
9
Press (Start).
If you need to designate the same area for multiple originals, remove the original
from the platen glass ➞ place all of the originals in the feeder ➞ press (Start).
Copying starts.
NOTE
•
To cancel this setting, press [Special Features] ➞ [▼] ➞ [Area Designation] ➞ [Pen
Entry] ➞ [Cancel].
•
To cancel all settings and return the machine to the Standard mode, press
(Reset).