User`s guide
Table Of Contents
- Manuals for the Machine
- How This Manual Is Organized
- Contents
- Preface
- How To Use This Manual
- Legal Notices
- All About Color
- Preserving Color Copies
- Introduction to Copying
- Basic Copying Features
- Special Copying Features - Document Layout
- Special Copying Features - Image Adjustment
- Special Copying Features - Scan Settings and Notifications
- Special Copying Features - Image Editing
- Special Copying Features - Color and Image Quality Adjustments
- Memory Functions
- Customizing Settings
- Appendix
Using Image Creation Modes
6-13
6
Special Copying Features - Image Editing
NOTE
•
If you make a mistake when entering values, press [C] on the inch entry pop-up
screen ➞ enter the correct values.
•
To enter values in millimeters, press [mm].
•
When entering values in millimeters, you can also use - (numeric keys), and
(Clear) to clear your entries.
•
If you enter a value outside the setting range for [X1], [X2], [Y1], or [Y2], a message
prompting you to enter an appropriate value appears on the screen.
•
For instructions on entering values in inches, see Chapter 2, "Basic Operations," in
the Reference Guide.
•
To change a value you entered, press [X1], [X2], [Y1], or [Y2] ➞ enter the correct
value using the numeric keys on the inch entry pop-up screen.
•
To check the designated area, press [Check Area].
•
To clear all your entries, press [Clear Area].
7
Press [OK] ➞ [Done] ➞ [Done].
The selected mode is set, and the display returns to the Copy Basic Features
screen.
8
Press (Start).
If you need to designate the same area for multiple originals using the edit pen,
remove the original from the platen glass after specifying the area ➞ place all of
the originals in the feeder ➞ press (Start).
Copying starts.
NOTE
•
To cancel this setting, press [Special Features] ➞ [▼] ➞ [Image Creation] ➞
[Image Repeat] ➞ [Cancel].
•
To cancel all settings and return the machine to the Standard mode, press
(Reset).