User`s guide
Table Of Contents
- Manuals for the Machine
- How This Manual Is Organized
- Contents
- Preface
- How To Use This Manual
- Legal Notices
- All About Color
- Preserving Color Copies
- Introduction to Copying
- Basic Copying Features
- Special Copying Features - Document Layout
- Special Copying Features - Image Adjustment
- Special Copying Features - Scan Settings and Notifications
- Special Copying Features - Image Editing
- Special Copying Features - Color and Image Quality Adjustments
- Memory Functions
- Customizing Settings
- Appendix
Using Image Creation Modes
6-10
6
Special Copying Features - Image Editing
❑ Designate the area using the edit pen.
Mark the two opposing points with the edit pen.
If you designate a point outside the permitted area, a message appears to
inform you that the specified position is not acceptable.
NOTE
•
To clear the first point entered, press [Erase Point]. (Once an area is designated,
[Erase Point] changes to [Clear Area].)
•
To clear a designated area, press [Clear Area].
•
To zoom in on any area on the original, press the ratio drop-down list ➞ select an
enlargement ratio ➞ press [ ], [ ], [▼], or [▲] to specify the area to display.
•
To check the designated area, press [Preview].
•
To modify a designated area that was specified using the edit pen, press [Area Fine
Adj.] ➞ [Point select] until the screen displays the desired point that you want to
modify ➞ press [ ], [ ], [ ], or [ ] to move the point ➞ press [Done] ➞
[Preview] to check the modified area.
❑ Press [OK].
The display returns to the Image Repeat screen.
Ratio