User`s guide
Table Of Contents
- Manuals for the Machine
- How This Manual Is Organized
- Contents
- Preface
- How To Use This Manual
- Legal Notices
- All About Color
- Preserving Color Copies
- Introduction to Copying
- Basic Copying Features
- Special Copying Features - Document Layout
- Special Copying Features - Image Adjustment
- Special Copying Features - Scan Settings and Notifications
- Special Copying Features - Image Editing
- Special Copying Features - Color and Image Quality Adjustments
- Memory Functions
- Customizing Settings
- Appendix
Frame Erase
4-23
4
Special Copying Features - Image Adjustment
3
Press [ ] or [+] to set the frame erase width ➞ press [OK] ➞
[Done].
The selected mode is set, and the display returns to the Copy Basic Features
screen.
NOTE
•
To enter values in millimeters, press [mm].
•
When entering values in millimeters, you can also use - (numeric keys), and
(Clear) to clear your entries.
•
You can change the value by pressing [ ] or [+], even if you have entered the value
using - (numeric keys).
•
If you enter a value outside the setting range, a message prompting you to enter an
appropriate value appears on the screen.
•
The default setting is '3/4" (18 mm)'. The maximum binding erase width that you
can set is '13/16" (20 mm)'.
4
Press (Start).
Copying starts.
IMPORTANT
If the original contains fine text or print, such as a map, the machine may need to
read or scan the document several times. Do not remove the original from the
platen glass until scanning is complete.
NOTE
•
To cancel this setting, press [Special Features] ➞ [Frame Erase] ➞ [Cancel].
•
To cancel all settings and return the machine to the Standard mode, press
(Reset).