User`s guide

Shifting the Original Image
4-5
4
Special Copying Features - Image Adjustment
5 Press (Start).
Copying starts.
NOTE
• To cancel this setting, press [Special Features] ➞ [Shift] ➞ [Cancel].
• To cancel all settings and return the machine to the Standard mode, press
(Reset).
Using the Numeric Keys
1 Place your originals ➞ press [Special Features] ➞ [Shift].
If necessary, see the screen shots in steps 1 and 2 of "Using the Arrow Keys," on
p. 4-3.
NOTE
If the desired setting is not displayed, press [▼] or [▲] to scroll to the desired
setting.
2 Use numeric keys on the inch entry pop-up screen to enter
the shift position.
❑ Press [No. Key Entry].
❑ Select the shift direction.
❑ Enter the shift value using the numeric keys on the inch entry pop-up screen.
❑ Press [Done].
NOTE
• To change a value you entered, select the shift direction ➞ enter the correct value
using the numeric keys on the inch entry pop-up screen.
• If you make a mistake when entering values, press [C] on the inch entry pop-up
screen ➞ enter the correct values.
• To enter values in millimeters, press [mm].
• When entering values in millimeters, you can also use - (numeric keys), and
(Clear) to clear your entries.
• If you enter a value outside the setting range, a message prompting you to enter an
appropriate value appears on the screen.
• For instructions on entering values in inches, see Chapter 2, "Basic Operations," in
the Reference Guide.