User`s guide
Table Of Contents
- Manuals for the Machine
- How This Manual Is Organized
- Contents
- Preface
- How To Use This Manual
- Legal Notices
- All About Color
- Preserving Color Copies
- Introduction to Copying
- Basic Copying Features
- Special Copying Features - Document Layout
- Special Copying Features - Image Adjustment
- Special Copying Features - Scan Settings and Notifications
- Special Copying Features - Image Editing
- Special Copying Features - Color and Image Quality Adjustments
- Memory Functions
- Customizing Settings
- Appendix
Transparency Interleaving
3-20
3
Special Copying Features - Document Layout
Transparency Interleaving
This mode enables you to automatically add an interleaving sheet of paper
between each sheet of transparency that is output. The interleaf sheets protect the
copied surface of the transparencies. You can also set to copy the content of the
transparencies onto the interleaf sheets.
IMPORTANT
•
The Transparency Interleaving mode cannot be used with the Multi-Page Enlargement,
Finisher, Two-sided, Two-page Separation, Cover/Sheet Insertion, Image Combination,
Booklet, Image Repeat, Mirror Image, or Area Designation mode.
•
You cannot make more than one set of copies at a time in the Transparency Interleaving
mode.
•
Even if an optional finisher is attached, you cannot use any of the Finisher modes with
the Transparency Interleaving mode.
•
Only LTR is available for the Transparency Interleaving mode.
NOTE
•
The machine's counter does not count blank interleaf sheets as copies.
•
Regardless of Tray Designation settings, transparencies are output as follows. The Tray
Designation settings may vary depending on the optional output units that are attached
to the machine. For instructions on using Tray A, B, or C, see Chapter 4, "Customizing
Settings," in the Reference Guide.
- Tray B if the optional Finisher-P1 and Copy Tray-J1 are attached
- Tray C if the optional Inner 2way Tray-C1 and Copy Tray-J1 are attached