User`s guide

Collating Copies
2-60
2
Basic Copying Features
■ If the Hole Punch Mode Is Set:
The machine punches two or three holes in the copies. The output is as follows:
IMPORTANT
• [Hole Punch] can be selected only if the optional Finisher-Q1 or Saddle Finisher-Q2 is
equipped with the optional Puncher Unit-M1.
• The Hole Punch mode cannot be used with the Multi-Page Enlargement, Saddle Stitch,
Booklet, or Transparency Interleaving mode.
• The machine automatically selects the number of hole punches (two or three holes),
depending on the selected paper size.
• You cannot punch holes in STMTR paper.
• Holes cannot be punched in transparencies, tracing paper, and labels.
■ If the Rotate Mode Is Set:
If the copies are of the same size, the sheets are automatically collated into sets arranged
in page order, and are output in alternating directions as follows:
IMPORTANT
• The Rotate mode cannot be used with the Multi-Page Enlargement, Automatic Paper
Selection, Cover/Sheet Insertion, Booklet, or Transparency Interleaving mode.
• You can only select LTR or LTRR paper.
• [Rotate] can be selected only if the machine is not equipped with an optional finisher.
- Two holes:
- Three holes:
LGL, LTRR
11" x 17", LTR
1
4
3
2
1
Originals Copies
4
3
2
1
1
1
1
Originals Copies