User`s guide
Table Of Contents
- Manuals for the Machine
- How This Manual Is Organized
- Contents
- Preface
- How To Use This Manual
- Legal Notices
- All About Color
- Preserving Color Copies
- Introduction to Copying
- Basic Copying Features
- Special Copying Features - Document Layout
- Special Copying Features - Image Adjustment
- Special Copying Features - Scan Settings and Notifications
- Special Copying Features - Image Editing
- Special Copying Features - Color and Image Quality Adjustments
- Memory Functions
- Customizing Settings
- Appendix
Changing the Copy (Zoom) Ratio
2-52
2
Basic Copying Features
If you select the stack bypass, the screens for specifying the paper size and
paper type in the stack bypass are displayed.
NOTE
The paper sources for transparencies and nonstandard size paper are grayed out
and cannot be selected.
6
Select the number of output pages ➞ press [OK].
Refer to the table under "Determining the Copy Ratio and Number of Sheets
Needed," on p. 2-43 as a guideline for specifying the number of output pages.
The display returns to the Copy Basic Features screen, and the copy ratio is
displayed as <Auto %>.
NOTE
The number of output pages that you have selected is used as a guideline. The
actual number of output pages may be less than what you have selected,
depending on a combination of factors that determine the most appropriate number
of pages. These factors include the size of the original, the selected paper size, and
the enlargement ratio.
7
Press (Start).
Copying starts.
NOTE
•
If you press (Stop) while copying is in progress to cancel the copy job and then
press (Start) again, copying resumes from the first sheet of the divided image.
•
To return the copy ratio to 100%, press [Direct].
•
To cancel this setting, press [Copy Ratio] ➞ [Multi-Page Enlarge] ➞ [Cancel].
•
To cancel all settings and return the machine to the Standard mode, press
(Reset).