User`s guide
Table Of Contents
- Manuals for the Machine
- How This Manual Is Organized
- Contents
- Preface
- How To Use This Manual
- Legal Notices
- All About Color
- Preserving Color Copies
- Introduction to Copying
- Basic Copying Features
- Special Copying Features - Document Layout
- Special Copying Features - Image Adjustment
- Special Copying Features - Scan Settings and Notifications
- Special Copying Features - Image Editing
- Special Copying Features - Color and Image Quality Adjustments
- Memory Functions
- Customizing Settings
- Appendix
Changing the Copy (Zoom) Ratio
2-41
2
Basic Copying Features
❑ Press [OK].
The machine automatically calculates the correct copy ratio based on the
values you entered; however, the original image may be cut off slightly on the
copy depending on the paper size.
If the computation results in a copy ratio less than 25% or greater than 400%,
a message appears telling you that values below 25% will be set to 25%, and
values above 400% will be set to 400%.
The selected mode is set, the display returns to the Copy Basic Features
screen, and the copy ratios generated by the machine for the X and Y axes are
displayed.
NOTE
•
If you make a mistake when entering values, press [C] on the touch panel display
➞ enter the correct values.
•
To enter values in millimeters, press [mm].
•
When entering values in millimeters, you can also use - (numeric keys), and
(Clear) to clear your entries.
•
For instructions on entering values in inches, see Chapter 2, "Basic Operations," in
the Reference Guide.
•
To specify the same copy ratio for both the horizontal (X) and vertical (Y) axes,
press [Zoom].
5
Press (Start).
Copying starts.
NOTE
•
To return the copy ratio to 100%, press [Direct].
•
To cancel this setting, press [Copy Ratio] ➞ [Zoom Program] ➞ [Cancel].
•
To cancel all settings and return the machine to the Standard mode, press
(Reset).