User`s guide

Changing the Copy (Zoom) Ratio
2-38
2
Basic Copying Features
❑ Press [OK].
You can enter either the width or the length of the original size. If you enter the
width for the original size, make sure to enter the width for the copy size as
well, and vice versa.
The machine automatically calculates the correct copy ratio based on the
values you entered; however, the original image may be cut off slightly on the
copy depending on the paper size.
If the computation results in a copy ratio less than 25% or greater than 400%,
a message appears telling you that values below 25% will be set to 25%, and
values above 400% will be set to 400%.
The selected mode is set, the display returns to the Copy Basic Features
screen, and the copy ratio generated by the machine is displayed.
NOTE
• If you make a mistake when entering values, press [C] on the touch panel display
➞ enter the correct values.
• To enter values in millimeters, press [mm].
• When entering values in millimeters, you can also use - (numeric keys), and
(Clear) to clear your entries.
• For instructions on entering values in inches, see Chapter 2, "Basic Operations," in
the Reference Guide.
• To specify the horizontal (X) and vertical (Y) axes independently, press [XY Zoom].
4 Press (Start).
Copying starts.
NOTE
• To return the copy ratio to 100%, press [Direct].
• To cancel this setting, press [Copy Ratio] ➞ [Zoom Program] ➞ [Cancel].
• To cancel all settings and return the machine to the Standard mode, press
(Reset).