Operation Manual

#
NOTE
•
Load the paper stack in stages, adding approximately 600 sheets of paper (64 g/m²
/ 17 lb bond) or 550 sheets of paper (80 g/m² / 20 lb bond) at a time. If the paper
deck can accommodate more paper, the lifter will descend.
•
Hot air blown by the fan may warm the inner size change plate of POD Deck
Lite-A1.
•
If there are instructions on the package of paper about which side of the paper to
load, follow those instructions.
•
When paper is loaded into the paper deck, the side facing up is the one printed
on.
•
If problems occur, such as poor print quality or paper jams, try turning the paper
stack over, and reload it. However, you cannot turn textured or 1-sided coated
paper over. Change this paper instead.
5.
Lower the feeding support roller.
If Paper Deck Unit-A1 is attached, proceed to step 6.
6.
Gently push the paper tray back into the printer until it clicks into place in the closed
position.
The inside lifter automatically rises and prepares the paper deck for feeding.
Chapter 9 - Paper, toner, and staples 261
Load the media into the bulk paper modules