User Manual

74
• Do not load the following types of paper into the Paper Deck Unit-A1/Paper Deck Unit-D1. Doing so may cause a paper jam.
• Severely curled or wrinkled paper
• Thin straw paper
• Heavy paper (more than 80 lb cover (220 g/m
2
))
• Paper which has been printed on using a thermal transfer printer
• The reverse side of paper which has been printed on using a thermal transfer printer
• Coated paper
• Tracing paper
• Transparencies
• Tab paper
• Labels
• Paper which is curled must be straightened out before loading it into the paper deck unit.
• Do not load paper into the Paper Deck Unit-A1/Paper Deck Unit-D1 that has been previously copied onto, as this may result in
a malfunction or damage to the machine. Always use the multi-purpose tray to feed paper when you want to copy onto the
back of a sheet of paper that already has something copied on its front side (2nd side of 2-Sided copy).
• Never place paper or any other items in the empty part of the paper deck unit next to the paper stack. Doing so may cause
paper jams.
• You will not be able to make copies or print if you load paper that exceeds the loading limit mark (
), or if the paper
drawer is not completely pushed into the paper deck unit.
• Make sure that the height of the paper stack does not exceed the loading limit mark (
).
• Always check that the paper deck unit is in place.
• Load the paper stack in stages, adding approximately 550 sheets of paper at a time. If the Paper Deck Unit-A1/Paper Deck
Unit-D1 can accommodate more paper, the lifter will descend.
• If there are instructions on the paper package about which side of the paper to load, follow those instructions.
• When paper is loaded in the Paper Deck Unit-A1/Paper Deck Unit-D1, the side facing up is the one printed on.
• If problems, such as poor print quality or paper jams occur, try turning the paper stack over and reloading it.
• Rewrap any remaining paper in its original package, and store it in a dry place, away from direct sunlight.
• If paper runs out and printing is stopped, load a new paper stack. Printing restarts after the new paper stack is loaded.