User`s guide

Setting Up the Connection
1-21
Before You Start Using This Machine
1
IMPORTANT
You cannot use the machine as a repeater, bridge, or gateway.
NOTE
• The machine can automatically detect the Ethernet speed (10Base-T or 100Base-TX).
• If you are using a mixed 10Base-T/100Base-TX environment, devices on the network
(hubs, routers, etc.) must support the mixed environment. For more information, consult
your local authorized Canon dealer.
• After connecting the network cable, perform the following operations. (For more
information, see the relevant descriptions.)
- Set the System Management Settings. (See Chapter 4, “System Manager Settings,” in
the Reference Guide.)
- Set the network settings. (See the Network Guide.)
- Install the printer driver if necessary. (See “Before Using the machine as a printer,”
on p. 1-22.)
Computer with
100Base-TX Connector
Computer with
10Base-T Connector
LAN Cable
Hub
The RJ-45 connector is located on
the back side of the machine.
Downloaded from ManualsPrinter.com Manuals