User`s guide

Collating Copies
2-28
2
Basic Copying Features
Collating Copies
The Finishing modes can be selected to collate the copies in various ways, either
by pages or copy sets.
IMPORTANT
The Finishing modes cannot be set if [Envelope], [Transparency], or [Labels] is selected
as the paper type.
NOTE
For instructions on using the optional Finisher-U2, see Chapter 3, “Optional Equipment,”
in the Reference Guide.
■ The table below shows all the Finishing modes that are available with each
different optional unit, and the paper sizes that can be used.
: Available
: Unavailable
*1 The copies are stapled at the part that represents the upper left corner of the original.
*2 The maximum when you are using 17 to 22 lb bond (64 to 80 g/m
2
) paper. If the number of sheets exceeds the
stapling limit, they will not be stapled.
Optional
Unit
Collate Offset Rotate
Staple
*1
None
11" x 17", LGL,
LTR , LTRR
LTR, LTRR
Finisher-U2
11" x 17", LGL,
LTR , LTRR
11" x 17", LGL,
LTR , LT RR
11" x 17",LGL,
LTRR (30 sheets)
*2
,
LTR (50 sheets)
*2
Inner 2 Way
Tray -E2
11" x 17", LGL,
LTR , LTRR
LTR, LTRR