User`s guide

Paper Selection
2-12
2
Basic Copying Features
NOTE
• For instructions on entering values in inches, see Chapter 2, “Basic Operations,” in
the Reference Guide.
• If you make a mistake when entering values, press [C] on the touch panel display
➞ enter the correct values.
• To enter values in millimeters, press [mm].
• If you enter values outside the setting range, [OK] is grayed out and cannot be
selected. Enter an appropriate value.
• You can adjust values for [X] between 5 7/8" and 17", and for [Y] between 3 3/4"
and 11 11/16".
❑ Press [Next].
❑ Select the desired paper type ➞ press [OK].
IMPORTANT
• When printing on special types of paper, such as heavy paper, be sure to correctly
set the paper type, especially if you are using heavy paper. If the type of paper is
not set correctly, it could adversely affect the quality of the image. Moreover, the
fixing unit may become dirty and require a service repair, or the paper could jam.
• If you select [Irreg. Size] for copying, you cannot use the Rotate Collate, Rotate
Group, Offset Collate, Offset Group, Staple, 1 2-Sided, 2 2-Sided,
Book 2-Sided, 2-Page Separation, or Image Combination mode.
NOTE
For more information on paper types, see Chapter 2, “Basic Operations,” in the
Reference Guide.