Setup Guide

2
Preparations
Remove the orange tape used to secure
the roll holder to the printer.
4
Three people should hold the printer's carrying handles and place the printer on a table or
other  at location.
When moving the printer,  rmly grasp the
carrying handles. Holding the printer at
other positions is dangerous, and may
cause injury and damage if the printer is
dropped.
•
3
The iPF770 Series weighs approximately
53 kg and the iPF670 Series approximately
43 kg by themselves. Moving the printer
requires at least three people. Be careful to
avoid back strain and other injuries.
•
Caution
Plug the power cord into the power supply
connector on the right of the printer and
plug the other end into the outlet.
Move the printer to the location where you
will use it.
6
5
When moving the stand, lift the support rod
to the position (a) before closing the output
stacker and unlocking the 4 casters. Failure
to do so may lead to scratched  ooring,
damage to the basket cloth, and injury.
•
After you have moved the stand, be sure to
lock the 4 casters.
•
Caution
The way to set the printer down or to carry
with the load only to the center of the
printer, may cause damage to the printer.
•When setting the printer down temporarily
make sure to put the printer on a  at, stable
place.
•
OF
F
a
ON
Prepare the printer for use by assembling the stand and connecting the power cord.
Remove the packing materials from the top of the printer.
2
Assemble the stand.
Refer to the Stand Setup Guide included with the stand for details
on how to assemble the stand.
Once you have  nished, proceed to step 4.
A stand is optional for the iPF670 series. (It may be included as a
standard accessory in some locations.)
If you are using the iPF670 series without a stand, proceed to step
2.
1