User's Manual

Control Panel
Paper Details
Setting Item Description, Instructions
Roll DryingT ime Specify the time to wait for the ink to dry for each sheet.
Scan W ait T ime Specify the time to wait for the ink to dry between each
scan in bidirectional printing, in consideration of how
quickly the ink dries. Note that printing will take longer if
you specify a wait time.
Feed Priority Specify exact paper feeding, if desired. Normally , select
Automatic . Choose Print Length if you prefer to feed
the paper an exact amount. However , note that choosing
Print Length may result in slight banding in the direction
of Carriage scanning.
Adjust Length Displayed if Feed Priority is Print Length .
Adjustment relative to the amount of stretching or shrinkage
of the current paper .
Enter either the adjustment results from Print Pattern or
the discrepancy that you measured (as a percentage).
For paper that tends to stretch, increase the feed amount
by choosing a higher adjustment value. For paper that
tends to shrink, decrease the feed amount by choosing a
lower adjustment value.
Head Height Adjust the Printhead height. ( → P .548)
Skew Check Lv . If you print on Japanese paper (washi) or other handmade
paper that has an irregular width, choose Loose for a
higher skew detection threshold, or choose Off to disable
skew detection. However , if paper is loaded askew when
detection is Off , note that paper jams or Platen soiling may
occur .
V acuumStrngth Specify the level of suction that holds paper against the
Platen . ( → P .557)
W idth Detection Specify this option to print inside boundaries, for example,
when printing at a dif ferent size than the paper size. Paper
width and skew are not detected if you select Off . If paper
is loaded askew , note that paper jams or Platen soiling
may occur .
NearEnd RollMrgn Specify the minimum margin at the leading edge of roll
paper to ensure better printing quality at the leading edge.
Note that if you choose 3mm , it may lower the printing
quality at the leading edge and af fect feeding accuracy .
The printed surface may be scratched, and ink may adhere
to the leading edge. It may also cause the Platen to
become soiled.
Cut Speed Choose the cutting speed. If you use adhesive paper ,
choosing Slow helps prevent adhesive from sticking to the
cutter and keeps the cutter sharp.
(The paper type is
displayed here.)( *1 )
T rim Edge First If a roll is loaded, the end of the paper will be cut.
50 Printer Parts