User's Manual

Cutter Unit
Replacing the Cutter Unit
Note
• For information on compatible Cutter Unit , see “Cutter Unit”. (→P .576)
• During Cutter Unit replacement, do not open the Carriage Cover . Ink will automatically ll the Printhead
after the Carriage Cover is opened, which consumes ink.
1. T urn the printer on. ( → P .22)
2. Press the Menu button to display MAIN MENU .
3. Select Maintenance → Change Cutter → Y es , and then press the OK button.
After the Carriage is centered, a message is shown on the Display Screen instructing you to
open the T op Cover .
Note
• If you do not respond within two minutes, cutter replacement is canceled and the printer goes online
automatically . In this case, repeat the steps above.
4. Open the T op Cover .
5. If the Cutter Unit or Carriage is dirty , use a damp cloth that you have wrung out completely
to wipe it clean.
Important
• Do not touch the Linear Scale (a) or Carriage Shaft (b).
Maintenance 577