User's Manual

Handling rolls

Selecting the Paper Source

When advancing paper , press the Feeder Selection button and select the source.

Y ou can determine the selected source by checking which lamp is lit-either the Roll Media lamp (a) or the

Cut Sheet lamp (b).

• Roll Media lamp : Selected when printing on Roll Media .

• Cut Sheet lamp : Selected when printing on Sheets .

Note

• If any paper is loaded that will not be used, a message is shown on the Display Screen , either Remove

roll? or Eject sheet? when you press the Feeder Selection button.

When removing the paper , press the OK button.

• Y ou cannot switch the paper source in the following situations:

• If the Message lamp is ashing

Check the message on the Display Screen and take action as necessary . ( → P .627)

• If the Data lamp is ashing

Select the paper source after printing.

• If a printer menu operation is in progress

Select the paper source after the menu operation.

• When in the process of loading paper

Finish loading the paper before selecting the paper source.

• When in the process of replacing Ink T anks

Finish replacing the Ink T anks before selecting the paper source.

• If the T op Cover is open

Close the T op Cover before selecting the paper source.

104 Handling Paper