Operation Guide

Set the PRISMAsync Remote Manager password
Introduction
When you start PRISMAsync Remote Manager ( How to start PRISMAsync Remote Manager on
page 12) you need to enter a password.
This password can be set in the Settings Editor of the printing system that runs PRISMAsync
Remote Manager.
You need to be a System administrator to carry out this procedure.
Procedure
1. Start Settings Editor.
2. Go to the [Configuration]Tab.
3. Select [Security].
4. In the [Passwords] section change the [Remote operator password].
An older system might show Operator password instead.
Set the PRISMAsync Remote Manager password
Chapter 3 - Configuration
31
PRISMAsync Remote Manager