Operation Guide

Enable PRISMAsync Remote Manager
Introduction
To be able to run PRISMAsync Remote Manager on a printer:
• The PRISMAsync Remote Manager license must be installed.
• The PRISMAsync Remote Manager function must be enabled.
You need to be a System administrator to carry out this procedure.
Check the license
1. Start Settings Editor.
2. Go to the [Support] Tab.
3. Select [Software].
4. Check for the PRISMAsync Remote Manager license.
If it is not available install the license.
Check if PRISMAsync Remote Manager is enabled
1. Start Settings Editor.
2. Go to the [Preferences] Tab.
3. Select [Printing workflows].
4. Check the [Remote Manager enabled] setting.
This setting must be enabled.
Enable PRISMAsync Remote Manager
30
Chapter 3 - Configuration
PRISMAsync Remote Manager