Operation Guide

Add [Remote printers]
Introduction
You must configure [Remote printers] before you can use [Copy to] to copy jobs to them.
Do this for each of the printers visible in the main view. Every printer has its own set of [Remote
printers].
NOTE
If you only configure the [Remote printers] on the printing system that runs PRISMAsync
Remote Manager than that is the only printer with [Copy to] functionality.
You need to be a System administrator to carry out this procedure.
NOTE
You should only use supported printers. See
Supported printers on page 8.
PRISMAsync Remote Manager uses the LPR protocol, check that the destination printers support
this.
Printers need to be able to handle or ignore an Océ JDF ticket in front of the job.
Procedure
1. Start Settings Editor.
2. Go to the [Workflow] Tab.
3. Select [Remote printers]
4. Use the [Add] button to [Add a printer].
If prompted, login as System administrator.
5. In the window [Add a printer] you have to enter the following information
• [Host name / IP address]
The IP address or hostname of the remote printer.
• [Description]
A descriptive text to make the printer easily recognisable.
This [Description] will be used to identify the printer in PRISMAsync Remote Manager.
If you do not enter a [Description] the IP address or hostname are used to identify the
printer in PRISMAsync Remote Manager.
6. Use the [Enable] button to enable/disable the following options
• [List of printers]
Add [Remote printers]
28
Chapter 3 - Configuration
PRISMAsync Remote Manager