Operation Guide

Definition
You need to be a System administrator to do the configurations for PRISMAsync Remote
Manager.
Enable PRISMAsync Remote Manager
To enable PRISMAsync Remote Manager follow the steps as described in Enable PRISMAsync
Remote Manager
on page 30.
The printer configuration
In the main view you get an overview of all configured printers.
These printers need to be configured on the printer that runs the PRISMAsync Remote Manager
software.
A maximum of 5 printers is supported.
The printer configuration is described here
Add a printer on page 26.
The [Remote printers] configuration
In PRISMAsync Remote Manager you can copy jobs from one of the configured printers to
another printer with [Copy to].
Before you can do this you must configure the possible destination printers as [Remote printers].
This should be done on all configured printers (from the printer configuration above).
Each configured printer can have a different configuration for [Remote printers]. When you use
[Copy to] you will see the [Remote printers] for that specific printer.
The [Remote printers] configuration is described here
Add Remote printers on page 28.
Add a printer
Introduction
All printers you add here, become visible the main view.
You need to be a System administrator to carry out this procedure.
NOTE
You can only add supported printers. See
Supported printers on page 8.
All printers need to be in the same time zone and use the same date and time (+/- 0.5 hour).
Procedure
1. Start Settings Editor.
2. Go to the [Workflow] Tab.
3. Select [Remote Manager].
4. Use the [Add] button to add printers.
If prompted, login as System administrator.
5. In the [Add printer] windows you have to enter the following information:
Add a printer
26
Chapter 3 - Configuration
PRISMAsync Remote Manager