Owner's Manual

#
NOTE
•
This operation can be performed while the device is operating.
•
The stacker can hold up to approximately 127 mm (equivalent to 10 booklets of
100 pages of 64 g/m
2
body pages / slip sheets and a cover of one 128 g/m
2
sheet)
or approximately 1000 sheets as a total. However, if the booklets contain body
pages / slip sheets that are heavier than 81 g/m
2
, the stacker may not be able to
hold booklets up to approximately 127.
•
The stacker has two LED's: a full LED and an open LED. Each LED indicates
the following.
- Full LED
Lit: The stacker is full or almost full.
Flashing: Binding operation is in progress.
- Open LED
Lit: the stacker is open.
Flashing: The stacker is preparing to open or close.
Off: The stacker is closed.
Removing finished booklets
1.
Press the open button and pull out the stacker.
The open LED flashes, then lights and the stacker automatically opens. Pull the stacker
out all the way until it stops.
#
NOTE
If the cutting is being operated inside the machine, the stacker may need some time
to open.
Chapter 3 - Basic operations50
Remove finished booklets