User Manual

Load the media into the special feeder (optional).........................258
Load tabs via the tab feeder (optional)...........................................262
Adjust the media size of the tab feeder (optional).........................269
Load the required media into the selected tray.............................272
Check the status of the punch waste box.......................................279
Removing the punch waste.............................................................280
Toner.......................................................................................................283
Check the status of the toner reservoir and waste toner container.283
Replacing the toner cartridge..........................................................285
Replacing the waste toner container..............................................291
Staples.....................................................................................................294
Check the status of the staple cartridges........................................294
Replacing the staple cartridge in the stapler unit..........................296
Replacing the staple cartridge in the saddle stitcher unit.............300
Chapter 10
Adapt printer settings to your needs............................................................305
System settings (access through the operator panel)........................306
Introduction to the 'Setup' section..................................................306
Work with the workflow profiles.....................................................308
Change the warning time................................................................312
Disable the warning time.................................................................313
Truncate the job name.....................................................................314
Adjust the brightness and contrast of the operator panel............315
Access Settings Editor settings via the operator panel.................316
Automated workflows (access through the Settings Editor)..............319
Introduction to automated workflows............................................319
Add an automated workflow...........................................................321
Edit an automated workflow...........................................................322
Delete an automated workflow.......................................................323
Restore the factory default workflow..............................................324
Hotfolders................................................................................................325
Introduction to hotfolders................................................................325
Activate the hotfolder function........................................................326
Create a hotfolder.............................................................................327
Create a shared network folder on a workstation..........................328
Create a hotfolder default ticket ('default_ticket.jdf').....................330
Chapter 11
Maintenance and calibration.........................................................................331
Maintenance...........................................................................................332
Introduction to the 'Maintenance' section......................................332
Reset the day counters.....................................................................334
Find the meter readings (counters).................................................335
'Auto color mismatch correction'....................................................336
6
Contents