User Manual

Main parts#
FunctionComponent
Pull out the punch waste tray to re-
move punch waste.
Punch waste tray1
Pull out the staple waste tray to dis-
card the staple waste.
Staple waste tray2
Finishing options
#
IMPORTANT
■
Do not place anything other than output paper in the trays of the finisher, as doing
so may damage the trays.
■
Do not place anything under the trays of the finisher, as doing so may damage
the trays.
[21]
#
NOTE
■
If the finishing is used, the output trays move downward as the stack of paper that
is output increases in quantity and thickness. Once an output tray has reached its
stacking limit, subsequent prints are automatically delivered to the next available
tray. If all of the available trays have reached their stacking limits, printing stops
temporarily. Remove all of the output paper from the trays. The trays move upward
and printing resumes.
■
If the optional Booklet Trimmer-D1 is attached to the Saddle Finisher-AJ2, you
cannot output stapled paper to the booklet.
#
CAUTION
Chapter 2 - Main parts 45
The stacker/stapler, optional inserter and optional integrated punch unit