User Manual

Note:
Instead of 12.34.56.78 you must enter the host name or IP address of the PRISMAsync
controller. Booklet is the name you gave to the hotfolder when you created the automated
workflow.
5.
Click 'Finish'.
A log in screen will appear.
6.
Enter the user name and the password that were defined when the hotfolder function
was enabled in the Settings Editor.
7.
Click 'OK.'
The hotfolder is now ready for use.
8.
If desired, you can create a shortcut to the shared network folder on the desktop of the
workstation.
■ Introduction to automated workflows, on page 319
■ Introduction to hotfolders, on page 325
■ Activate the hotfolder function, on page 326
■ Create a hotfolder, on page 327
■ Create a shared network folder on a workstation, on page 328
■ Create a hotfolder default ticket ('default_ticket.jdf'), on page 330
Chapter 10 - Adapt printer settings to your needs 329
Create a shared network folder on a workstation