User Manual

Replacing the staple cartridge in the saddle stitcher unit
Introduction
This section describes how to replace the staple cartridge of the saddle stitcher.
#
IMPORTANT
■
Take care when handling the optional equipment that is attached to the machine.
When an optional unit's cover is opened to replace a staple cartridge, discard punch
waste, or clear paper or staple jams, prints may still be output if other optional
units are operating normally, and are not involved in the paper or staple jam re-
moval procedure.
■
If necessary, remove all of the output paper in the booklet tray before replacing
the staple cartridge in the saddle stitcher unit.
#
NOTE
■
This procedure is necessary only if the optional Saddle Finisher-AJ2 is attached.
■
Since both the front and inner staple cartridges need to be replaced when staples
run out in the saddle stitcher unit, we recommend that you order staple cartridges
from your local authorized dealer before your stock runs out.
Replacing the staple cartridge in the saddle stitcher unit
1.
Open the front cover of the finisher.
Chapter 9 - Paper, toner, and staples300
Replacing the staple cartridge in the saddle stitcher unit