User Manual

Load tabs via the tab feeder (optional)
Introduction
Before you install the tab feeder, check the paper size of the tab feeder.
#
IMPORTANT
You cannot use A4 tab paper whose tab width is 13.5 mm / 35/64"or less, measured
from the edge.
13.5 mm
#
IMPORTANT
Make sure that you fan the sheets of tab paper well before placing them.
You can only load A4 or Letter tab paper to the tab feeder. Before you install the tab
feeder you must check the paper size of the tab feeder. If required, change the paper size
of the tab feeder. See ‘Adjust the media size of the tab feeder (optional)’ on page 269
#
NOTE
The following types of tab paper are available.
4
3
2
1
1
2
3
4
1 2
■
Right order tab (1)
■
Reverse order tab (2)
Chapter 9 - Paper, toner, and staples262
Load tabs via the tab feeder (optional)