User Manual

15.
When you have finished aligning the rear edge retainer with the marks for the desired
paper size, fasten the rear edge retainer to the outer size change plate with the blue screw
using a coin or something similar.
16.
Make sure that the inside lifter has lowered, and load the remaining paper into the paper
tray.
NOTE
When loading paper, make sure that the height of the paper stack does not exceed 20
mm. If the height of the paper stack exceeds 20 mm, the edges of the paper stack may
become curled or creased, and poor print quality may result.
17.
Close the paper tray.
#
CAUTION
When returning the paper tray to its original position, be careful not to get your
fingers caught, as this may result in personal injury.
18.
At the operator panel, touch 'OK' to close the information window.
Chapter 9 - Paper, toner, and staples256
Adjust the outer size change plate of the bulk paper module (optional)