User Manual

2.
Load a stack of paper into the paper tray, so that the height of the paper stack does not
exceed 10 mm.
If you are using A4 paper, load a second stack of paper on the side of the first paper stack,
so that the outer size change plate is not tilted.
#
IMPORTANT
If you have loaded a second stack of paper for fine adjustment, make sure to remove
it after adjusting the outer size change plate. Leaving the second stack of paper in the
paper tray may lead to a paper tray malfunction.
3.
Close the paper tray. Wait until the open button stops flashing.
4.
Continue on the operator panel.
■
Touch 'System' -> 'Maintenance'.
■
Press 'Start maintenance'.
■
Press 'Adjust paper tray plates'.
Chapter 9 - Paper, toner, and staples252
Adjust the outer size change plate of the bulk paper module (optional)