User Manual

The zoom behavior
Introduction
When you carry out a copy job or scan job, you can use the Zoom function to reduce or
enlarge an image, for example:
■
Copy an A4 original on an A3 sheet. The system enlarges the image
■
Copy an A3 original on an A4 sheet. The system reduces the image
■
Copy an A4 original with a small illustration on an A4 sheet, and at the same time
enlarge the illustration.
By factory default, the zoom function is set to Fit to page. This makes sure that no infor-
mation is lost. To change the zoom factor manually, touch the - and + buttons of the
Zoom function in the job window. If you use non-standard size originals, you must use
the glass plate. The scanner can not automatically detect the size of the originals on the
glass plate. Therefore, you must select the original size manually.
The zoom function for originals in the automatic document feeder is different from the
zoom function for originals on the glass plate.
Zoom behavior#
Starting point of the zoom functionOriginal
CenterAutomatic Document
Feeder
Upper left-hand cornerGlass plate
This section describes the characteristics of the zoom function when you use the automatic
document feeder or the glass plate.
#
NOTE
The zoom function works identical for both copy jobs and scan jobs.
Scan from the automatic document feeder and use the zoom function
The following table shows the zoom behavior of the machine when the originals are
scanned from the automatic document feeder. The focus is on the centre of the original.
Chapter 7 - Copy jobs 197
The zoom behavior