User Manual

Shift the image roughly to create binding space

Introduction

If you want to create space for staples or punch holes, for example, you can use the 'Align'

function. The preview in the right-hand pane of the operator panel displays the conse-

quences of your changes.

The 'Align' function allows a rough image shift. You can select one of the following set-

tings:

■

'Top left' - The image is moved to the upper left corner of the sheet.

■

'Center' - The image is moved to the middle of the sheet.

■

'Top right' - The image is moved to the upper right corner of the sheet.

You can also shift the image or margin more precisely.

How to change the alignment

Touch 'Jobs' -> 'Waiting jobs'.

Touch the job you want to change.

NOTE

You can not change this setting for the active print job .

Touch 'Properties' - or touch the job 2x to open the 'Properties' window.

Touch the 'Align' button.

Make the required changes.

Press 'OK'.

■ Shift the image precisely to create binding space or correct the layout, on page 162

Chapter 6 - Print jobs 161

Shift the image roughly to create binding space