User Manual

Adjust the paper tray to hold a different media size.....................240
Load the media into the bulk media module (optional)................245
Adjust the media size for the bulk media module (optional)........252
Adjust the outer size change plate of the bulk paper module (option-
al).......................................................................................................261
Load the media into the special feeder (optional).........................268
Load tabs via the tab feeder (optional)...........................................272
Adjust the media size of the tab feeder (optional).........................279
Load the required media into the selected tray.............................282
Check the status of the punch waste box.......................................289
Removing the punch waste.............................................................290
Toner.......................................................................................................293
Check the status of the toner reservoir and waste toner container.293
Replacing the toner cartridge..........................................................295
Replacing the waste toner container..............................................301
Staples.....................................................................................................304
Check the status of the staple cartridges........................................304
Replacing the staple cartridge in the stapler unit..........................306
Replacing the staple cartridge in the saddle stitcher unit.............310
Chapter 10
Adapt printer settings to your needs............................................................315
System settings (access through the operator panel)........................316
Introduction to the 'Setup' section..................................................316
Work with the workflow profiles.....................................................318
Change the warning time................................................................322
Disable the warning time.................................................................323
Truncate the job name.....................................................................324
Adjust the brightness and contrast of the operator panel............325
Access Settings Editor settings via the operator panel.................326
Automated workflows (access through the Settings Editor)..............329
Introduction to automated workflows............................................329
Add an automated workflow...........................................................331
Edit an automated workflow...........................................................332
Delete an automated workflow.......................................................333
Restore the factory default workflow..............................................334
Hotfolders................................................................................................335
Introduction to hotfolders................................................................335
Activate the hotfolder function........................................................336
Create a hotfolder.............................................................................337
Create a shared network folder on a workstation..........................338
Create a hotfolder default ticket ('default_ticket.jdf').....................340
Chapter 11
Maintenance and calibration.........................................................................341
6
Contents